Labounty CP 80, Safety, Operation & Maintenance Manual

Page: 19 / 46

CONCRETE PULVERIZERS
Installation Section 3 Page 5
CONCRETE PULVERIZER REMOVAL
1 . Fully close the pulverizer and place it on a solid, level surface in the position shown in fi gure 3-7.
2 . Support the position arm while removing the pin from the mounting pad then lower the position arm to the
ground.
3. Remove the pin from linkage connection.
4. Remove the pin from the main pivot. With all personnel standing clear, carefully raise the excavator stick
away from the puliverizer.
CONCRETE PULVERIZER STORAGE
1 . Place the attachment on a solid, level surface.
2 . Apply a coating of grease to the bores, pins, and any other exposed, unpainted surface.
3. Replace all pins in their bores to prevent misplacing them.
4. Grease at all locations (refer to the lubrication instructions in the maintenance section of this manual).
FIGURE 3-7