LABORIE Solar Blue, Service & Installation Manual

Page: 52 / 198

© 2008
– 2020 by MMS B.V.
51
The procedure is as follows:

Connect the power adapter to the DC receptacle. Make sure that the Solar
Blue module is connected to the correct power adapter (type PS-SBL). Do
not use a power adapter other than which is specified. Doing so may cause
fire leading to serious accidents.

The Status LED will be green.

The Battery LED is unlit.
The DC receptacle on the Solar Blue module should be kept clean for optimal
performance.
4.2.4 USB interface
The USB interface is used to connect the Solar Blue module to the computer
via a USB cable.
Figure 4.6 USB interface
The cable between the Solar Blue module and the computer is used:

when modules like the flowmeter or the puller, are connected to the Solar
Blue module via the MMS-bus receptacles (more information about MMS-
bus receptacles can be found in § 4.2.6). Otherwise it is not possible to use
these modules (more information about conditions when a flowmeter, puller
or is connected via a cable can be found in § 6.2.1

when you don’t use a wireless Bluetooth connection between the Solar
Blue module and the computer.

to download new software versions into the Solar Blue module (this is
faster than by the wireless connection).