LABORIE Solar Blue, Service & Installation Manual

Page: 25 / 198

24 © 2008
– 2020 by MMS B.V.
Chapter 2
2.5 Solar Blue on Pole
The Solar Blue module can be mounted on the Solar pole (Ø38mm). For this
situation, the computer (laptop) and printer can be put on a table. The Solar
Blue module communicates per wireless Bluetooth connection with the
computer.
Figure 2.3 Example Wireless pole setup
The installation procedure is as follows:

Install the LABORIE software (see the software installation manual
(document code 0075-MAN-092-EN)).

Assemble the Solar pole (Ø38mm).

Assemble and install the Solar Blue module (see chapter 4).

Mount the Solar Blue module to the Solar pole (Ø38mm).
CAUTION
When mounting the Solar Blue module on the pole with the
clamp, make sure not to tighten the plastic clamp with too much
force.

If applicable, install the safety module (see § 2.7).

Install the devices as supplied with your system: remote control (chapter 5),
Bluetooth flowmeter (chapter 6), Bluetooth puller (chapter 7), or the Luna
module (chapter 8).

In case of pressure measurement with water catheters, mount the
transducer holder to the Solar pole (Ø38mm) directly.