Measurement Program
Solar Blue User Manual
181
•
Confirm stop investigation
•
Use puller for profile
•
Puller speed/manual pull speed
•
Artefact detection
•
Initial values marker
Create report immediately after the investigation
When the setting
Print report
is set to
always
or
optional
, the report can be
created immediately after the investigation, using the selected report
configuration defined in the protocol. To select the configuration, click the
Reporter
button behind
Print report
or behind
Save report to PDF
. In the
dialog box, you can also edit the printer settings/PDF settings for the report.
The selected report configuration will be saved per protocol, per investigation
type. The printer and PDF settings will be saved globally for all protocols, but
only for the reports that will be created after the measurement. You can find
more information about the reporter program in the separate
Reporter Manual
in PDF format, which you can open via the
Manuals
menu in the database
program.
Channels and connections
In the protocol, you must set the channels for each investigation (e.g., Pves,
Pabd, Pdet) to be measured and the connections for each channel. Use the
buttons
Channels
and
Connections
to set this information. For more
information, see § 12.5.8 and § 12.5.9.
Click the
Transducer
button to choose the transducers used during the
investigation. In most cases, just select standard pressure transducers. Only
change this setting when
you’re using user-calibrated transducers. The
Catheter
button is not used for urodynamic investigations.
12.5.8
Channel settings
Click the
Channels
button to display the
Channel settings
dialog box shown
in Figure 12.15.
This dialog box provides an overview of all available channels. For each
investigation, you can set the following:
•
The channels to be measured (e.g., P
ves
, P
abd
, P
ura
, EMG)
•
The channels to be calculated (e.g., P
det
, P
clos
)
•
The layout of these channels (e.g., color, position, scale)
