single-pole switch
Firstly, connect the electric cable of the motor to a test cable.
Four wires exit the motor: yellow-green (earth), blue (neutral), brown and black (up and down direction). Three wires exit the fuse box:
yellow-green (earth), blue (neutral) and a phase wire. Connect the wires as shown on the diagram.
The phase wire exiting the fuse box is to be connected to clamp P. If necessary, reverse the brown and black wire of the motor within the
switch, so that the arrows on the switch correspond to the raising and lowering direction of the awning.
Connect the two blue wires in the housing of the switch by means of a cableclamp. Do the same for the two earth wires.
setting of the end switches of the motor
In principle the end switches of the motor are already set at the factory.
But it may be necessary to change the setting.
For this proceed as follows:
First remove the yellow cap from the adjusting buttons.
Press in both adjusting buttons fully, against their stops. The end settings are now fully removed in both directions.
Now allow the awning to roll out until the desired position is reached.
Note : never allow arms to go past their straightened position but stop them a little before.
Then place the switch to its neutral.
Press the white or yellow button ( depending on the building-in-side) so that it rises slightly. Then roll up the awning again and stop at a
distance of 10 cm before the closing of the awning. Then press the blue setting button and have it rise slightly.
Let the motor run down for 20 cm.
Then close the awning completely. One can hear the motor hum for a few seconds ( to compensate a possible later dilatation of the fabric )
and then switch itself off.
Replace the cover cap on the button.
The end switches of the motor are now set.
