3-2 How to change the Blade Receptacle Plate
As shown in the below picture, remove Entry Guide(2screws), Front Fixing Plate(2screws) and
Film Press Plate(2screws)
Entry Guide・Front Fixing Plate・Film Press Plate
Then, untighten screws(4pcs)of the Film Guide Section(Below, left)
N.B. Do not attempt to remove the screws, otherwise the inner springs may be off.
Remove the fixing screws(2pcs)of the Blade Receptacle Plate and pull out it by lifting up towards
the back.
Untighten 4 screws
Blade Receptacle Plate
3-3 How to assemble the Film Guide Section
N.B. 1. Assemble to the Film Guide Section with care. Be sure on the matching pitches of screws.
Assemble it in the reversed order of detaching.
Fix the Blade Receptacle Plate and tighten 4 screws of the Film Guide Section.
When attaching the Film Press Plate, adjust the holes of Blade Receptacle Plate and Film Press Plate.
Be careful to attach the Front Fixing Plate so as not to override the hole of Blade Receptacle Plate.
Assemble the Entry Guide by sliding it from the left of the Film Press Plate.(Below right, arrow marked)
After assembling, check whether or not the Film Positioning Plunger will return to the original position
by pushing the Film Positioning Plunger(click-stopped) and Lock Pin.
Holes of Blade Receptacle
Entry Guide
Film Positioning Plunger
Plate & Film Press Plate Holes of Blade Receptacle
Lock Pin
Plate(3pcs)
- 4 -
