Introduction
The Labnet Vortex Mixer is a general purpose laboratory vortexer. Mixing speed is
adjustable up to 3,400rpm. A three position switch allows the mixer to be operated
continuously or by “touch” activation. The shaking mechanism is specially designed to
offer enhanced stability under various loads. The metal baseplate and rubber feet
provide additional stability and prevent the unit from “walking” across the bench, even at
maximum speed.
Read this manual thoroughly before attempting to operate the Vortex Mixer. All persons
operating this piece of equipment should review the Safety Precautions section of this
manual.
Specifications
Speed Range
3400rpm (60 Hz)
2850rpm (50 Hz)
Operating Modes
Touch or Continuous
Ambient Operating Range
+4ºc to 65ºc
Dimensions (w x d x h)
14 x 16 x 12 cm
Weight
2.2 kg
Electrical
120V, 60Hz, 0.6A
230V, 50Hz, 0.3A
Unpacking the Vortex Mixer
Upon receipt of the Vortex Mixer, examine the exterior carton for damages. In the event
of shipping damage, a claim must be filed with the transportation carrier within 10 days
of receipt. Save all packaging for inspection by the carrier.
Carefully unpack the unit and check for completeness. Included in the carton should be
the following:
Vortex mixer with cup head
Line cord
Instruction manual
If any of these items are missing, contact Labnet’s Customer Service Department
immediately. Save the original packaging until the unit has been shown to be operating
properly.
Verify that the unit is rated for the proper voltage by checking electrical / serial no. label
on the back.
Installation
Locate the mixer on a level, stable surface near a grounded electrical outlet. The
surface should be clean and free of dust to ensure that the feet grip the surface firmly.
Allow sufficient clearance on all sides of the unit for proper ventilation.
With the power switch in the OFF position, plug the power cord into a grounded
receptacle.
Operating the Vortex Mixer
All operating controls are located on the front panel. The power switch, located on the
left side of the panel, has three positions - TOUCH, OFF and ON. When set to the
TOUCH position, the mixer is activated by depressing the mixing head. When pressure
