Instructions for Use
1) Turn temperature and speed to zero before plugging in. And connect the Main power cord
topower supply. Place your container or heating bath with the magnetic stirrer bar. Stirrer bar
should be placed in center of hot plate
2) Turn Power Switch ON.
Stirring Instructions
D0310, D0320
1. Fill vessel with solution to be stirred.
2. Place stir bar into vessel.
3. Turn power switch ON. Then Hot Top Indicator Lamp will illuminate.
4. Turn Stir Control Knob until the desired speed.
5. Speed On Indicator Lamp will illuminate when the motor runs.
6. Heating and stirring can be performed simultaneously on the D0320 models which offer both
heating and stirring functions.
7. When the desired stirring is complete, turn the Stir Control Knob to “0” position. Allow stir bar
to cease rotation before removing the vessel from the unit.
8. Disconnect Main power cord from the unit.
9. Keep the product dry and clean disconnecting Main power cord when the unit is not used for
a long time.
Note:
1) Range of speed control : 100~1500 RPM
2) Speed control knob in extreme left (CCW) position stops operating.
3) If motor does not run upon turning the knob, increasing until 100rpm or more
Please note that the viscosity of the stirred material will affect the ability of the stir bar to remain
coupled to the rotating ring magnet. Materials of high viscosity must be stirred at slower speed
settings.
6
No
Desc Analog Hotplate Stirrer
Hot Top Indicator Lamp
Heat Control Knob
Temperature On Indicator Lamp
Speed On Indicator Lamp
Stir Control Knob
Summary of Contents for AccuPlate D0300
Page 12: ......
