Instruction Manual |
3
5.2 Controls
ON/OFF rocker switch
– located on back of unit. Turns primary power on and off
Start/Stop LED
,
red
– used to activate or stop the unit. Illuminates when unit is in heating mode, off in
temperature set mode
Heating LED
,
red
– illuminates when unit is in heating mode and unit is actually apply heat to the block.
This LED is on continuously during heat-up and cycles and off when the unit is at set temperature.
Time LED, green
– used to set or select time mode. This LED light indicates running Time Mode.
TEMP-UP arrow key
– raises set temperature when unit is in set mode.
TEMP-DOWN arrow key
– lowers set temperature when unit is in set mode
Timer-UP arrow key
– raises set time when unit is in set mode.
Timer-DOWN arrow key
– lowers set-time when unit is in set mode. To enter continuous mode, set the
time to 00:00, hold the Timer-DOWN arrow key while pressing the
Start/Stop key
– unit will display “Hold”
6.0 Operation
1. Place Labnet Dry Bath Incubator on a sturdy and level surface in a safe, dry place, away from
laboratory traffic.
2. Ensure that the AC power switch is OFF, then plug the three-pronged power cord into a grounded
three-prong AC outlet of the appropriate voltage (115V or 220V as indicated on the rating sticker
near the AC cord on the back of the unit).
3. Select suitable module block(s) or appropriate water volume and put it/them into the Labnet Dry
Bath Incubator
4. Turn the AC power ON.
5. Run temperature calibration procedure when using the instrument for the first time.
6. Press
▼
or
▲
key to adjust to the desired temperature.
7. Press
▼
or
▲
key to adjust to the desired timer.
8. Press
Start/Stop
key to start heating.
9. If to reset timer is required during heating, press
Start/Stop
key to deactivate heating.
10. Press
Start/Stop
key again to stop the unit.
11. If lid is to be used, aim the shaded area on the dry bath surface with the magnet of the lid and it will
be attached to the housing. In order to remove the lid, press one hand firmly on the housing with
another hand pulling the lid off. To use the lid, the tube should not be exceeding 25 mm than the
heating block.
