LabelStation Pro 240
Page 57 of 67
3. Start the Diagnostic Utility by double-clicking the
icon.
Note:
This utility does not work with printers of early version firmware. The printer must have
V6.00 firmware or later.
4. Select “COM” as interface then click on the “Setup” button to setup the serial port baud rate,
parity check, data bits, stop bit and flow control parameters.
5. Click on the “Ethernet Setup” button from printer function of Printer Configuration tab to setup the
IP address, subnet mask and the gateway for the on board Ethernet.
5.3 Using Ethernet interface to setup Ethernet interface
1. Connect the computer and the printer to the LAN.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double-clicking the
icon.
Note:
This utility does not work with printers of early version firmware. The printer must have
V6.00 firmware or later.
4. Select “Ethernet” as the interface then click the “Setup” button to setup the IP address, subnet
mask and gateway.