Labelmate - The World’s Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
SET-UP
• Slide the Flange Plate onto the brass shaft
• Install the three (3) metal vanes onto the shaft. The side with the 3 holes for the screws has to be facing the rotation
direction.
• Position the Plastic Flange Plate even with the inside end of the Shaft so there is clearance between the Flange and the
Chassis.
• Tighten the screw in the Hub until it is snug.
• CAUTION: AVOID ACCIDENTS. THE UCAT-S WEIGHS OVER 6KG, SO CHOOSE ONLY A STURDY SURFACE ON WHICH
TO SET THE UNIT.
Your UCAT-S is now ready for use.
LABEL UNWINDING FOR PRINTING
The UCAT-S is bi-directional. It can unwind labels in either direction.
• Slide the roll of labels to be unwound / slit onto the shaft of the UCAT-S and all the way up against the Plastic Flange
Plate.
• Thread the labels into the printer / slitter as required
• Begin the printing operation and observe that the labels are feeding correctly into your printer / slitter.
• If necessary, adjust the position of the UCAT-S so the alignment with the printer / slitter is appropriate to correctly feed
the labels.
• Braking is adjusted by turning the red knob.
•
OPTIONAL:
The tension is adjustable via the red knob. This knob can be replaced with a regular M5 screw so the adjustment can
only be made with a wrench, in order to prevent the operator to change the brake setting.
Getting started
