SPECIFICATION
Lab.gruppen AB, Gullregnsvägen 16, SE-434 44 Kungsbacka, Sweden.
Tel. +46 300 168 23. Fax +46 300 142 46. www.labgruppen.se
2002
SPEAKER PROTECTION
Each channel is fuse protected on the positive and negative power supply rails. Electronic short-circuit protection with a progressive
characteristic. The output power is turned off at shorted output. The power amplifier can be run into short-circuits for a long time
without damage, and is open circuit and mismatch proof.
DISTORTION
THD 20 Hz-20 kHz and 1 W-1000 W
THD at 1kHz and 1100W
DIM 30 at 500 W
CCIF (13 and 14 kHz) at 500 W
SMPTE (60 Hz and 7 kHz) at 500 W
POWER BANDWIDTH
3)
Slew rate
OUTPUT IMPEDANCE
HUM AND NOISE below max power
CHANNEL SEPARATION
PHASE AND DELAY
Deviation from perfect delay
Total delay input to output at 4 ohms
INPUTS
Sensitivity, switchable for full output into 4 ohms
Gain, switchable
Impedance
Common mode rejection at 1 kHz
FRONT PANEL
Gain controls
Output display
Temp indicator
VHF indicator
On indicator
REAR PANEL
Input connectors
Output connectors
Switches:
Gain
Link
Polarity B
Clip limiter A and B
MLS
POWER
Operation voltage
Minimum start voltage
Full output power
Peak inrush current
OVERALL DIMENSIONS
mm (inch)
WEIGHT
APPROVALS
-5 dB
160 W
300 W
570 W
1040 W
600 W
1140 W
2080 W
-4 dB
180 W
350 W
680 W
1200 W
700 W
1360 W
2400 W
-2 dB
340 W
650 W
1100 W
1200 W, 1400 W
2)
1300 W
2200 W
2400 W
0 dB Full
520 W
1100 W
1400 W, 1900 W
2)
1400 W, 2900 W
2)
2000 W
2800 W
2800 W
IHF
Peak power
20 ms
520 W
1200 W
1900 W
2900 W
2000 W
3800 W
5800 W
Lab.gruppen reserve the right to alter functions or the specifications without prior notice.
4 ohms
4 ohms
4 ohms
4 ohms
4 ohms
1 kHz
1 kHz
10 kHz
150 Hz-20 kHZ
(2) Channel A - B
(2) red + (10) green LED´s
(2) yellow LED´s
(2) yellow LED´s
(2) green LED´s
CE
0.08 %
0.03 %
0.02 %
0.03 %
0.08 %
5 Hz-20 kHz
20 V/µs
0.06 ohm
<- 105 dBA
90 dB
80 dB
± 2°
19 µs
0.775 or 2,2 Vrms
38 dB or 29 dB
20 kohms, balanced
50 dB
Fast peak - slow release
80_ C at heatzink
> 10 kHz at full power
DC rail voltage for channel A and B
(2) XLR type 3 pin female (pin 2+), and (2) 1/” jack
(2) Neutric 4-pole speakon connectors (pin 1+ output)
38 dB or 29 dB
Tandem mono, channel A and B
Polarity reverse of channel B
On - Off
0, -2, -4, -5 dB
Option
130 V - 270 V AC
65 V-135 V AC
190 V AC
95 V AC
180 V -260 V AC
90 V-130 V AC
4.5A
483 (19”) W
x 88 (3.5”) H
x 347 (13,7”) D
10 kg (22 lbs)
Emission EN 55 103-1, E3
Immunity EN 55 103-2, E3, with S/N below 1%
at normal operation level
4)
Safety EN 60 065, class I
1) Specifications measured with 230 V regulated AC
2) Continuous power, one channel driven or peak power both channels
driven. (Thermal protection may occur at high continuous power).
MAX OUTPUT POWER
1)
EIA at 1 kHz and 1% THD
MLS switch
16
Ω
stereo
8
Ω
stereo
4
Ω
stereo
2
Ω
stereo
16
Ω
bridged
8
Ω
bridged
4
Ω
bridged
3) The VHF-protection turns off the channel for frequencies
above 20 kHz at full power.
4) Normal operation level 1/8 of full power or -9dB below clip point.