10
FA Series
Quick Start Guide
11
FA Series Controls
Controls
(1)
Input LEDs
- Light green for signal and red
for limit/fault.
(2)
POWER LED
- Lights blue for power on and
yellow for sleep mode.
(3)
Mains connector
– Connect the IEC cable to
a mains outlet.
(4)
Config switches
– Configure the output
channel for the connected load type.
See ‘Getting Started’ section for details.
(5)
Output
– Connect your speaker(s).
(6)
Remote
– Allows the connection of an
external volume control module per channel.
CRC-V available as a separate accessory.
(7)
Euroblock input
– Accepts 3-pin Euroblock
connectors for balanced line-level sources.
Input A is routed to Output A, Input B is routed
to Output B, etc.
(8)
Input Level switch
- 4 for line-level
sources and -10 for mic-level sources.
(9)
Gain
- Adjust the gain level for each input.
If the respective front panel LED lights red,
reduce the gain to avoid clipping.
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(1)
(2)