Lab12 mighty- Class A Single Ended Power Amplifier
Page
7
of
8
Main connections
Connect a High-Grade Power cable to the IEC input and to your wall socket. Make sure that your wall
socket provides a good ground before connecting the power cable
.
You must supply 230 to 240 Volt
AC/50Hz (115 to 120 AC Volts / 60Hz). (Every
mighty
is tuned and calibrated using the
Lab12 Knack
mk2 Power Cable.
We strongly suggest using this cable).
Connect to your Preamplifier
Connect the preamplifier analog output to the analog line level input of your mighty Power Amplifier.
Make sure about the correct channel connections. We suggest using a good quality interconnect cable
pair.
Connect your Speakers
Connect your speakers to the additional output of mighty (connect speakers from 2 to 6 ohm at
4ohm
positive bind, speakers from 6 to 16 ohm at
8ohm
bind). Make sure about the phase and polarity of
speakers,
always connect ‘’plus’’
(red) bind of Mighty to ‘’plus’’
(red) bind of speaker and same with
black.
Notes:
You can choose the operation of mighty between
Triode or Ultra Linear pentode mode
, to tune the
sound closest to your taste.
This can be done thru two toggle switches on the back of power tubes. Position both switches
towards to transformers for triode mode or towards to tubes for Ultra Linear pentode mode.
You can change the operation even when amplifier is turned on with just lowering the volume.
Mighty is fully compatible with the best octal tubes (EL34, 6550, KT88). You can use any of these three
types of tubes with no problem.
