La Sommeliere MT166DP, Use Instruction

Page: 24 / 72

24
5. USE INSTRUCTIONS
When selecting a location for your appliance you should make sure the floor is flat and firm, and the
room is well ventilated. This device is suitable for operation in rooms with a very specific ambient
temperature, this climatic class is indicated on the nameplate. The ambient temperature affects the
interior temperature and humidity of your cellar. For optimal operation, your cellar settings are made
for ambient temperatures of 23 ° C to 25 ° C.
The temperature of the device is adjustable between 5°C to 20°C. The temperature is regulated by a
thermostat. Changing the temperature generates higher energy consumption.
When the surrounding temperature is 25
℃
and the wine cellar has no bottle loaded, it will take around
30 minutes to increase the temperature from 5
℃
to 20
℃
.
Under the same circumstance, it will take around one hour to decrease the wine cellar temperature
from 20
℃
to 5
℃
.
IMPORTANT: to optimize the operation of the appliance, it is important to set the temperatures
respecting a difference of 10°C maximum between the upper and lower compartment (18 and
8°C for example).
MT166DP
– Control panel
A. Press and hold for 3 seconds to switch between modes. The key is used either to set the
temperat
ure unit between degrees Celsius “°C” and degrees Fahrenheit “°F” or to turn the device
lighting ON or OFF.
B. Button to increase the set temperature by 1°C in the upper zone
C. Temperature display, upper zone
D. Button to decrease the set temperature by 1°C in the upper zone
E. Button to increase the set temperature by 1°C in the lower zone
F. Temperature display, lower zone
G. Button to decrease the set temperature by 1°C in the lower zone
H. Selection button to choose the temperature zone to be set (upper or lower zone). When the zone is
selected, the temperature display becomes flashing; then press the temperature adjustment buttons.
Handle installation
This wine cellar includes a stainless steel handle.
To install the handle please follow the below instructions:
1.
Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2.
Align the handle with the screws installed. Tighten the screws using a Phillips head
screwdriver until the handle sets both flush and secured tightly against the door frame. (DO NOT over
tighten as this will cause damage to the handle assembly).
3.
Replace the door gasket to its original position.
4. If you choose not to use the handle supplied, simply follow step 1 to access the installation
screws and remove them and then place the two decorative plugs into the two holes separately.
Continue on to step 3 to replace the door gasket to its original position.