26
English
– press for ground coffee
– rubber tube with stainless steel mesh for water connection (water circuit - water softener)
– rubber drain hose with steel coil for water drain
– 3/8” nipples for hose connection to water supply tube
– cleaning brush for serving units
– water filter before pump (on request)
– rubber tube with stainless steel mesh of 600mm for water connection (water circuit - water softener)
– rubber tube with stainless steel mesh of 1600mm for water connection (water circuit - water softener)
4.2 Water mains set-up
fEEDING LINE
Bring the water feeding tube (of at least 3/8” diameter) up to the machine and install an on-off valve (preferably of
3/8” ball type) that allows a rapid opening and closing operation. The machine should be connected to the water
mains using the tube supplied with it. Do not connect the machine with used tubes.
DRAIN LINE
Provide an inspectable drainage pit on the floor connected with the sink drainage line, suitable for receiving
the machine gravity drainage tube. The drain tube must be positioned so that the water flows out freely,
without possibility for the pipe to clog up during the operation.
4.3 Water softener (optional)
The water softener for softening the mains water can be manual or automatic, depending on
customer’s request.
Before connecting the water softener to the coffee machine, the resins contained in it should be
washed off as described in the user’s manual supplied with the appliance.
Note:
The water softener is considered an essential device to guarantee a proper operation of the espresso coffee ma-
chine. A water softening system should be provided in order to guarantee the efficiency, performance and duration
of the components in the machine.
4.4 Installation of water system
1) Use the pipe
32
(900 mm, provided with the machine) to connect the cut-off valve of the mains to the tap
for water inlet to the water softener (figure 1).
2) Connect pipe
36
(1600 mm, provided with the machine) to the tap of water softener with the tap of the
coffee machine water system (figura 2 – 3).
4.5 Installation of water system with motor pump (optional)
1) Use the pipe
32
(900 mm, provided with the machine) to connect the cut-off valve of the mains to the tap
for water inlet to the water softener (figure 1).
2) Connect the pipe
35
(600 mm, provided with the machine) for pump suction (see diagram of water feed
system) to the tap of the coffee machine water system (figure 3).
4.6 Drain line
Connect the drainage tube to the grounds collecting tray and to the water drainage system.
figure 1
figure 2
figure 4
32
36
36
