La Proromance HSS-A, User Manual

Page: 6 / 88

6
HEATER STAND AND LOCATION
•
The heater is intended for outdoor use only. Always ensure that
adequate fresh air ventilation is provided.
•
Always maintain proper clearance to non protected combustible
materials i.e. top 100 cm and sides 100 cm minimum).
•
Heater must be placed on level, firm ground.
•
ever operate heater in an explosive atmosphere, such as in areas
where gasoline or other flammable liquids or vapors are stored.
• To protect heater from strong wind, anchor the base securely to
the ground with screws.
GAS REQUIREMENTS
• Use propane, butane or their mixture gas only.
•
The pressure regulator and hose assembly to be used must
conform to local standard codes.
•
The installation must conform to local codes, or in the absence of local codes, with
the standard for the storage and handling of liquid petroleum gases.
•
A dented, rusted or damaged tank may be hazardous and should be checked by your
tank supplier. Never use a tank with a damaged valve connection.
•
The tank must be arranged to provide for vapor withdrawal from the operating
cylinder.
•
Never connect an unregulated tank to the heater.
LEAKAGE TEST
Gas connections on the heater are leak tested at the factory prior to shipment. A
complete gas tightness check must be performed at the installation site due to possible
mishandling in shipment or excessive pressure being applied to the heater.
•
Make a soap solution of one part liquid detergent and one part water. The soap
solution can be applied with a spray bottle, brush or rag. Soap bubbles will appear in
case of a leak.
•
The heater must be checked with a full cylinder.
•
Make sure the safety control valve is in the OFF position.
•
Turn the gas supply ON.
•
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the
gas supply on and recheck.
•
Never leak test while smoking.