LA NORDICA EOLO, Installation, Use And Maintenance Manual

Page: 28 / 80

28
EOLO - COMFORT 80
EN
Fig. 31 - Burning pot removal Fig. 32 - Burning pot cleaning Fig. 33 - Burning pot glass positioning
• Remove the burning pot (see Fig. 31 page 28 ) from its housing by lifting it as shown in the picture and empty
it from ash.
• If necessary clean the obstructed holes from encrustations with a pointed object (see Fig. 32 page 28 ).
• Clean the glass and replace it in the burning pot on its fitting bearing cleft (see Fig. 33 page 28 ).
Fig. 34 - Ash tray Fig. 35 - Clening with a brush
• Removing the ash tray (see Fig. 34 page 28 ) from its housing by lifting it and empty it from ash.
• Clean also the hole for pellet dropping with a brush (see Fig. 35 page 28 ).
• The ash must be put in a metal container with a sealed lid. The same container must not ever get in touch
with flammable materials (for example leant on a wooden floor), because the inner ash keeps burning for a
long time.
• Only when the ash has extinguished it can be wasted in the organic waste.
• Pay attention if the flare colours with red shades, if it is faint or if emits black smoke: in this case the burning pot
is encrusted and needs to be cleaned (see Fig. 32 page 28 ). If it is worn out it must be replaced.
14.3 COMBUSTION CHAMBER CLEANING
Every week combustion chamber and ash tray cleaning must be executed.
Fig. 36 - Fire pot room cleaning Fig. 37 - Ash tray room cleaning Fig. 38 - Upper part cleaning
• Open the door.
• Remove and clean the burning pot and the ash tray.
• Clean through ash suction which has amassed inside the combustion chamber (see Fig. 36 page 28 ) and
inside the ash tray room (see Fig. 37 page 28 ).
• Extract also ash in the upper part of the tubes which lye on the combustiona chamber (see Fig. 38 page
28 ).