Manual
Barista Milk Mate 1.5
© La Cultura Del Caffè GesmbH
04.09.2015
Page 30 | 36
Usually it is not necessary to update the bootloader. The update involves certain risks (e.g. at loss
of power during the update) and so this should only be done when absolutely required!
4.3.3
Clear databuffer
In some situations it may make sense to clear all data (event memory and product counters) in the
non-volatile memory of the device. This can be done here.
4.4
General settings
All basic settings, essential for the device to work as intended by the installer, have to be
configured under "General".
4.4.1
General
Login code
Define the PIN code used for entering the menu on the device (see chapter 3.5).
In fact there is a default value for this PIN code (which is created when starting a new file) but it
can be changed at any time. By doing so the code must have between 2 and 9 digits.
Device language
The language used on the device can be pre-selected here.
Backlight timeout
Set the period of time it will take until the display backlight fades out (since the last display touch
event).
Maximum allowed value is 250 sec.
If a permanent display backlight is requested (no dimming) this parameter has to be set to 0.
Standby timeout
Describes the period of time after which the standby screen is shown again.
Maximum allowed value is 250 sec.
Zero means that the standby screen will not be displayed at all.
NOTE: The standby screen is the one that shows the adjusted standby image.
