5
The transmitter is in a standby state. It does
not perform any operation and the LCD is off.
Under a bright condition, press the reset
button to wake up the transmitter into normal
operation mode (battery voltage is higher
than 2.5V)
The most power saving mode.
TO INSTALL / REPLACE BATTERY IN THE
SOLAR STATION
The Solar Station can use either the included 2 x
alkaline rechargeable battery (charged by solar
panel; included) or 2 x AA alkaline battery (non-
rechargeable; not included).
INITIAL SETUP
It is very important to
follow these steps
:
1.
First, remove the label covering over the
battery compartment on the back.
2.
Open the battery compartment, and
MAKE
SURE
that the battery switch is in the
BATTERY
position (not the SOLAR
position).
Battery switch in the BATTERY position
3.
Now locate the battery insulator tab, and
gently pull to remove it.
4.
Slide the battery switch to the SOLAR
position
6
5.
Battery switch in the SOLAR position
6.
Continue to section titled “
Setup After
Changing/Installing the Battery in the
Solar Station
”
TO INSTALL / REPLACE BATTERY IN THE
SOLAR STATION
The included alkaline rechargeable batteries
should provide you with many years of service. If
your batteries need to be replaced, we suggest
you use 2 fully charged the AA Alkaline.
Rechargeable batteries should be fully charged
before inserting into clock.
Alkaline rechargeable
batteries must be used.
If you choose to use non-rechargeable batteries,
the battery switch MUST be moved to the
BATTERY
position (not the SOLAR position). In
this position, the solar cells do not charge the
batteries.
REGARDLESS OF THE TYPE OF BATTERIES
INSTALLED, THE BATTERY SWITCH MUST BE
IN THE BATTERY POSITION WHEN THE
BATTERIES ARE INSERTED.
If rechargeable batteries are used, the Battery
switch should be moved to the SOLAR position
AFTER it is has been inserted.
7
To use non-rechargeable alkaline batteries:
1.
Remove the included rechargeable AA
batteries from the compartment.
2.
Use the switch to select the alkaline battery
(see below).
3.
Insert the batteries into the compartment,
observing the correct polarity (see marking
inside battery compartment.
4.
Replace battery cover
Note
: For best performance, batteries should be
replaced at least once every 2 years to maintain
the best running accuracy. Ensure that the
batteries used are new and the correct size.
Use switch to
select which type
of battery will be
used before
inserting the
battery into the
compartment
Battery cover
8
Please help in the preservation of the
environment and return used batteries to
an authorized depot.
SETUP AFTER CHANGING/REPLACING THE
BATTERY IN THE SOLAR STATION
1.
After powering up the Solar Station, all LCD
segments will light up briefly and it will show
the indoor temperature and humidity data.
2.
Next, the Solar Station will start receiving
data signal from the solar transmitter. The
outdoor temperature data should then be
displayed on the Solar Station. If this does
not happen after 2 minutes, the batteries will
need to be removed from both units and
reset from step 1.
3.
The distance between the Solar Station and
Rechargeable Alkaline
battery switch position
Primary Alkaline
battery switch position
