38
Relearn Mode (Relearn Tx)
→
Allows to clear all weather data in
non-volatile buffer memory (EEPROM) and to newly recognize
the outdoor transmitter (e. g. after a battery change in the
transmitter) without the necessity of a comprehensive re-setup of
all system components
→
Acknowledge with
٭
CONFIRM
٭
.
Default Settings (Factory Reset)
→
Allows the reset of all set
and/or stored values to the factory settings set prior to shipment
→
Acknowledge with
٭
CONFIRM
٭
.
Note:
It will take 5 minutes for the factory reset process. During this
period, the text “Factory Reset In Progress” will be shown. After
the reset process is finished, the LCD will switch off and the text
“Remove Battery” will be displayed. Remove the battery and
perform system start again. See “3 - Putting in Operation”
paragraph.
Leaving the basic settings procedure (Setup Mode) with
٭
EXIT
٭
.
5
Display of stored Min/Max Values and Alarm Value
Settings
Named values are in each case upon recall being simultaneously
displayed and flashing in their respective display sections.
To recall named measuring and alarm values the menu shown
below will have to be activated by touching the Touch Screen in
the center of the text display section (last two lines at the bottom
of the LCD). The display of the values is started by touching the
displays
٭
MINMAX
٭
or
٭
ALARMS
٭
resp.
