7
after 60 seconds, remove the batteries and wait for at least 10 seconds before
reinserting them.
3.
After inserting the batteries into the sensor, the Temperature Station will start
receiving data from the sensor. The outdoor temperature and the signal reception
icon should then be displayed on the Temperature Station. If this does not happen
after 5 minutes, the batteries will need to be removed from both units and reset from
step 1.
4.
In order to ensure sufficient 915 MHz transmission however, there should be no more
than 330 feet (100 meters) between the final position of the Temperature Station and
the sensor (see notes on “
Mounting
” and “
915 MHz Reception
”).
5.
Once the remote temperature has been received and displayed on the Temperature
Station, the WWVB time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions—but may take up to 4 nights.
6.
If after 10 minutes, the WWVB time has not been received, press the SET key to
manually enter a time initially.
When more than one sensor is to be used
1.
User shall remove all the batteries from the Temperature Station and sensors and
wait 60 seconds if setting has been done with one sensor before.
2.
Insert the batteries to the first sensor.
3.
Within 60 seconds of powering up the first sensor, insert the batteries into to the
