VII.
Battery clip
REPLACING THE BATTERY
The battery can either be replaced by a qualified jeweler or watch repair shop,
or by the user.
Any damage resulting from this procedure is not covered under warranty.
WARRANTY INFORMATION
La Crosse Technology provides a 1-year warranty on this watch. Contact La Crosse Technology
immediately upon discovery of any defects covered by this warranty. Before sending the watch in
for repairs, contact La Crosse Technology. The watch will be repaired or replaced with the same
or similar model. This warranty does not cover any defects resulting from improper use,
unauthorized repairs, faulty batteries, or the watch’s inability to receive a signal due to any source
of interference.
1.
Remove the four screws located
on the back and remove the cover.
Be sure the watch movement and
gasket do not come out of the
case.
LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL,
CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH
THE OPERATION OR MALFUNCTION OF THIS WATCH. THIS PRODUCT IS NOT TO BE
USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS
NOT A TOY. KEEP OUT OF CHILDRENS’ REACH.
2.
Remove the old battery by gently
prying up the battery clip.
This warranty gives you specific legal rights. You may also have other rights specific to your
State. Some States do no allow the exclusion of consequential or incidental damages therefore the
above exclusion of limitation may not apply to you. For warranty work, technical support, or
information contact
3.
Insert a new battery of the type
“CR1620” 3 Volt Lithium Cell
battery
Battery
compartment
4.
Please dispose of the old
battery properly.
La Crosse Technology
190 Main Street
La Crescent, MN 55947
Phone: 507.895.7095
Fax: 507.895.8000
TROUBLESHOOTING
Problem:
No WWVB signal (indicated by the absence of the WWVB tower icon).
Solution:
1) Check the selected Time Zone. If it is set between GMT+1 and GMT
+12. The WWVB signal will not be received because the watch is
programmed not to search when outside of the range of the WWVB signal.
Change the Time Zone to one of the time zone of the U.S and the watch
will again search for the WWVB signal overnight.
2) Move watch 10 feet (3 meters) away from any interfering sources, i.e.
electrical appliances (refrigerators, TV’s, computers), metal surfaces or
objects.
3) To help with overnight reception, place watch in a window with the
band inline with the general direction of Ft. Collins, Colorado.
4) There are a few places the signal is very weak (Los Angeles area, Some
parts of Florida and New York City). Since the watch has a much smaller
receiver than our other clocks, it is possible no reception can be made.
Please inform La Crosse Technology in this case.
Problem:
The hour or minute is incorrect, even though the tower icon is on
(indicating a successful reception of the WWVB time signal the previous
night) and it is set to the proper time zone.
Solution:
1) Electrical interference caused the time signal to be improperly received.
Be sure the watch is at least ten feet from any source of electrical activity
(television, computer). Overnight it should correct itself.
2) You may need to perform a manual WWVB search. Please follow the
directions outlined in section III.
Warranty work
Information on other products
Or visit us on the internet at
www.lacrossetechnology.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
Note:
For all questions not answered please contact La Crosse Technology (contact
information is below).
