TABLE OF CONTENTS
Topic
Page
Quick Setup
3
Inventory of Contents
4
Detailed Setup Guide
Battery Installation
5
Setting the Time
6
Features
Minimum and Maximum Temperatures
6
Resetting Minimum and Maximum Temperatures 6
Adding additional remote
temperature sensors (optional)
6
Weather Forecast
7
Weather Icons
7
Tendency Arrow
8
Mounting
9
Troubleshooting
9
Maintenance and Care
10
Specifications
11
Warranty Information
11
QUICK SETUP
Hint: Use good quality Alkaline Batteries and avoid recharge-
able batteries.
1. Have the indoor temperature station and remote tempera-
ture sensor 3 to 5 feet apart.
2. Batteries should be out of both units for 10 minutes.
3. Place the batteries into the remote temperature sensor
first then into the indoor temperature station.
(All remote temperature sensors must be started before
the indoor temperature station)
4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES.
In this time the indoor temperature station and remote tem-
perature sensor will start to talk to each other and the display
will show both the indoor temperature and an outdoor
temperature. If the indoor temperature station does not dis-
play both temperatures after the 10 minutes please retry the
set up as stated above. After both indoor and outdoor tem-
peratures are displayed for 10 minutes you can place your
remote temperature sensor outdoors and set your time.
The remote temperature sensor should be placed in a dry,
shaded area. The remote temperature sensor has a range
of 80 feet. Any walls that the signal will have to pass through
will reduce distance. An outdoor wall or window will have 20
to 30 feet of resistance and an interior wall will have 10 to 20
feet of resistance. Your distance plus resistance should not
exceed 80 ft. in a straight line.
NOTE: Fog and mist will not harm your remote temperature
sensor but direct rain must be avoided.
To complete the set up of your indoor temperature station
after the 10 minutes have passed please follow the steps in
the detailed set up guide on page 5-6.
INVENTORY OF CONTENTS
1. The indoor weather station (Figure 1)
2. The remote temperature sensor (TX6U) and mounting
bracket. (Figure 2)
3. 3 each, 1/2" Philips screws.
4. One strip of double sided adhesive tape.
5. Instruction Manual and Warranty Card.
ADDITIONAL EQUIPMENT (not included)
1. 1 Philips screwdriver.
2. 2 Fresh AA Alkaline batteries.
3. 2 Fresh AA Alkaline batteries
DETAILED SETUP GUIDE
Battery Installation
1. Install 2 AA batteries in the remote temperature sensor.
Make sure they do not spring free, or start-up problems
may occur.
2. Install 2 AA batteries in the indoor weather station. Do
not press any buttons for at least ten minutes.
Figure 1
Figure 2
Holder
GB
P.2
GB
P.3
GB
P.4
GB
P.5
