5
PROGRAM MODE
After the batteries have been installed the minute digits of the time display will flash,
signaling that the program mode has been automatically entered. If no buttons are
pressed, the digits will stop flashing after 50 seconds. To enter the programming mode
(when not automatically entered) hold down the
RAIN/SET
button for 2 seconds—the
minute digits will flash. The Program Mode is laid out in a manner that allows you to
program each function separately, or you can follow the instructions entirely to program
the Rain Monitor. Complete programming is usually done for the initial set-up, and will
require you to skip step 1 of programming sections II through VI.
I) FUNCTION
BUTTONS
There are 2 function buttons located on the front of the Rain Monitor, and under the
LCD screen. The function buttons are labeled:
RAIN/SET
, and
H
. See
Figure 1.
II) TIME SETTING
1) Hold down the
RAIN/SET button
for 2 seconds, or until the minute-digits
flash.
2) Press
the
H button
to adjust the minutes.
3) Press
the
RAIN/SET button
to confirm the minutes and to shift to set the
hour.
4) The hour-digits should now be flashing. Press the
H button
to
adjust the hour.
Note:
An “A” (a.m.) or a “P” (p.m.) will appear to the right of the time
display, set the time accordingly.
5) Press
the
RAIN/SET button
to confirm the hour setting, and to advance to
set the date.
III) DATE SETTING
1) Hold down the
RAIN/SET button
for 2 seconds, press the
RAIN/SET button
2 more times—until the first digit of the date (the month) flashes (default is
“1.1”).
2) Press
the
H button
to adjust the month.
3) Press
the
RAIN/SET button
to confirm the month, and to shift to set the date.
4) Press
the
H button
to adjust the date.
5) Press
the
RAIN/SET button
to confirm the date, and to advance to set the
weekday.