11
II)
THE WIRELESS RAIN MONITOR
The Rain Monitor can also be mounted in two ways:
•
with the table stand or,
•
on the wall with the use of a wall hanging screw (not included).
A)
USING THE TABLE-STAND
1.
The Rain Monitor comes with the table stand already mounted. If you
wish to use the table-stand all that is required is to place the Rain
Monitor in an appropriate location.
B)
WALL MOUNTING
1.
Remove the table stand. To do this,
pull down on the stand from the rear
and rotate forward. (Figure 3).
2.
Fix a screw (not included) into the
desired wall, leaving approximately
3/16 of an inch (5mm) extended from
the wall. (Figure 4).
3.
Place the Rain Monitor onto the screw
using the hanging hole on the
backside. Gently pull the Rain
Monitor down to lock the screw into
place.
MAINTENANCE & CARE
•
Extreme temperatures, vibrations, and shock should be avoided to prevent damage to
the units.
•
Clean displays and units with a soft, damp cloth. Do not use solvents or scouring
agents—they may mark and damage the displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries to avoid leakage and damage.
Replace with new batteries only, and of recommended size.
•
Opening the casings invalidates the warranty. Do not try to repair the units. Contact
La Crosse Technology for Repairs.
Figure 3
Figure 4