12
Add-On Sensors
EXTRA SENSORS
Whether you choose to connect with the La Crosse View app or not, this alarm clock can display data for
up to 4 extra sensors. This data will appear in the green section on the LCD, in your projection image, and
in your La Crosse View app if connected. To learn about all of you add-on sensor options, visit:
bit.ly/add-on_sensors
2.
Install batteries into your sensor. If the sensor has a
TX
button, press it to force a transmission signal.
This button is usually located in or near the sensor’s battery compartment. The LED light on the sensor
will flash once.
3.
Your sensor should connect within the next 3 minutes, briefly displaying its ID and type on the LCD.
The Sensor Reception Indicator will show solid on the screen when a sensor is connected.
Adding Extra Sensors to Your Alarm Clock
1.
Hold the
EXTRA
button until you see the Sensor Reception Indicator start to animate.
Note:
When first powering up, or after a factory reset, extra sensors should automatically connect to your alarm clock.
Viewing Your Sensor Data: LCD
Viewing Your Sensor Data: Projection
Thermo-Hygro Sensor Data
Indoor Temp. & Humidity
Water Leak Sensor Data
Add-On Water Leak Sensor Data
Press & release the
EXTRA
button to cycle
through the data you’d like displayed on the LCD.
The Auto Scroll Icon ( ) will appear if activated.
2.
Press the
+/-
buttons to select ALT WITH TIME ON.
3.
4.
Press the
PROJ INFO
button to toggle through
the selections.
Press the
SNOOZE/LIGHT
button to exit the
Projection Menu.
1.
Hold the
PROJ INFO
button to choose the
Alternate Projection Mode. ALT WITH TIME OFF
will appear on the LCD.