La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 9
03 = Mountain
02 = Central
01 = Eastern
4. Press the SET button to confirm and select day light saving time indicator
setting.
5. ON will flash.
6. Press the
▼
or
▲
buttons to select DST OFF.
7. Press the SET button to confirm and select the hours.
8. The hours will flash.
9. Press the
▼
or
▲
buttons to set the hours.
10. Press the SET button to confirm and select minutes.
11. The minutes will flash.
12. Press the
▼
or
▲
buttons to set the minutes.
13. Press the SET button to confirm and select snooze duration.
14. The snooze duration will flash (05-60 minutes).
15. Press the
▼
or
▲
buttons to set the snooze duration.
16. Press the SET button to confirm and exit.
No WWVB Tower Icon
The digital clock has not received a WWVB time signal in the past 24 hours.
Position
the digital clock for better reception.
Hold the - button to send the Digital clock on a WWVB signal search at night.
Allow up to 5 nights to receive the time signal.
1.
When your clock is powered on, it starts to receive WWVB signal for seven
minutes. The tower icon will flash.
Note: During reception of the WWVB time signal, the buttons will not function.
The LED will change to low brightness and will return to high brightness after
WWVB search.
•Receiving WWVB signal (tower icon flashing)
•Successful Reception (tower icon is solid)
•Failed Reception (no tower icon)
2.
During reception, press and hold the
▼
/ WAVE button, your clock will give a
short beep and stop the WWVB signal reception.
3.
During reception, press
▼
/ WAVE button once to show reception mode and
signal strength indication:
•When strong WWVB signal is detected, the display shows with three bars
•During reception, the signal strength may move from one bar to two bars to
three bars.
4.
This is normal since the clock is detecting WWVB signal and other signals in the
air at the same time.
5.
Press SET will return to the time display with tower icon flashing.
Weather station is blank: No letters, numbers or dashed lines
Check that the AC adapter. Is it correctly installed and connects to an active
outlet.
Press any button 20 times. Leave the alarm clock unpowered for 1-2 hours.
Power clock with AC adapter only to determine if batteries were an issue.
