65
Installation Guide - "Château" Range G4
08NOTINSTALG4/EN-1
IGNITION – ADJUSTMENTS
Injectors
Injectors for gas burners
The replacement of the burner and cast iron solid top injectors has to be done as follow:
u
Remove the pan support or the solid top.
v
Remove the burner cap.
w
Unscrew the injector with 7 mm standard wrench. Place the new injector and
screw it.
x
Replace the burner cap on the burner.
y
Replace the pan support or the solid top.
Injector for gas oven
Injector for lava rock grill
The gas oven or grill injectors are always replaced in the following sequence:
u
Screw the adjusting cone (2) and insert it into the mixing tube in order to free
sufficient space for unscrewing the injector.
v
Unscrew the injector (1) using a no. 7 open-end spanner for the stone grill or no. 17
for the oven.
w
Install the injector (1) corresponding to the new type of gas and tighten it.
x
Adjust the air inlet (A) (see table below for adjusting the primary air) by screwing or
unscrewing the adjusting cone (2). Ignite the burner, the flame must be slightly blue
without separation; separation of the flame is an indication that there is too much air.
y
Then block the adjusting cone (2) with the blocking washer (3).
GAS BURNER AND CAST IRON SOLID TOP
Burner cap
1
3
2
2
3
a
1
