WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
27
5. To Replace a Hob Element
a). Disconnect the appliance from the electricity supply.
b). Lift up the induction hob (see Section 2). The
Induction Heating Elements (IHE) are now accessible.
Note the wire connection positions and element
orientation for re-assembly. Disconnect the wires,
and remove the element unit.
c). Re-assemble in the reverse order.
d).
Note:
The IHE will require commissioning when the
hob has been refitted.
6. To Replace a Light Switch
a). Disconnect the appliance from the electricity supply.
b). Remove the control panel (see Section 1).
c).
Note:
The old switch may be destroyed during
removal.
d). Remove the old switch from its bezel by gripping the
switch body behind the control panel and twisting
sharply. Remove the switch bezel by folding back its
locking wings and pushing forward. Fit the new bezel
to the control panel by first lining up the raised key
on its body with the cut-out in the control panel and
pushing it in from the front.
e). Assemble the new switch to the bezel by lining up
the key sections and pushing home. Fit the new
button by pushing in from the front.
f). Replace the Control Panel in reverse order and test
for correct operation.
7. To Remove the Induction Unit
a). Disconnect the appliance from the electricity supply.
b). Remove the control panel as detailed in Section 1.
c). Lift the induction hob as detailed in Section 2.
d). Lift the front of the induction unit.
e). Disconnect the wire from the display control unit.
f). Disconnect the supply wires from the hob terminal
block – 6 wires.
g). Remove one of the induction unit hinges (remove 3
screws) and remove the induction hob.
8. To Remove a Thermostat
a). Disconnect the appliance from the electricity supply.
b). Remove the control panel as detailed in Section 1.
c). Remove the induction hob as detailed in Section 2.
d). Open the appropriate oven door and remove the
oven shelves.
e). Remove the oven linings. Lift each lining upward and
slide forward off the support brackets
(Fig.8.2)
.
f). Remove the two screws holding the thermostat phial
to the oven fan cover at the rear of the oven.
Fig.8.2
