MPM-1000A Operator Manual
1000-7075 Rev E
8-16
Table 8-3 NCW Statistics Tab
Control/Indicator/Function
Description
Reference FOW
The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
These statistics also indicate the measured signal to noise ratio (SNR) of
the RFOW bursts.
Assigned ROW
The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
NM-only Terminals are not required to receive AROW bursts, so this field
is blanked for NM-only Terminals.
Data COMM
The statistics shown represent the number of failed burst acquisition
attempts versus the number of bursts assigned, as well as the number of
bursts with CRC failures versus number of bursts successfully acquired.
Byte/Packet Counts
Displays total bytes/packets of IP traffic for both transmitted and received
user data traffic.
Reset Time
Time that statistics were last reset. Reset button to reset all statistics.
Statistics Time
Time that statistics were last requested.
Polling
Automatic polling parameters. The minimum interval is 1 second.
Elapsed Time (seconds)
Displays the total time between the last statistics reset and the last
statistics update.
Number of nodes in network
(seconds)
Count of active network nodes.
Reset
Button to reset the statistics and counts to zero.
Statistics
Button to request currents statistics (if polling not enabled).
Hint
Right clicking on one of the status boxes will bring up a
Thresholds
dialog.
Use this dialog to change the default thresholds and changing the colors
of the status boxes between green, yellow and red based on the error
percentage.
