L-TEC IONSTAR 14882, User Manual

Page: 18 / 30

Seite 18 von 30
6.
Getting started
Connect the IONSTAR to the compressed air supply.
The device is grounded is via the compressed air hose

An electrically conductive compressed air hose must be used with the
IONSTAR

Ensure that the incoming air pressure to the pistol is within minimum 3 to
maximum 5 bar
The ionization device is ready for operation
7.
Scope of application
Point the ionizer at the part to be cleaned and press the operating lever.
• Distance 10 - 40 cm
• During operation, the green LED lights up
- LED off = no ionisation
- LED blinks off and on = only partial ionisation. Check that incoming
pressure is within required range of minimum 3 to maximum 5 bar
- LED on = ionisation in progress; normal operation
• When used as intended, the IONSTAR device also complies with the technical
regulation TRGS 727, version 8/2016, “avoidance of ignition hazards due to static
charges”
Helpful paint-spraying tips

Use your IONSTAR in the same way, with the same pressure and at the
same distance as you would use your spray gun.

Use a dust cloth; apply this BEFORE ionizing with your IONSTAR, NOT at the
same time.

Ionize thoroughly. Do not forget parts like door frames, flanges and beads
etc.

Coat immediately after ionizing.

For best results, ionize between the application of each layer.

Do not touch the vehicle after ionizing with your IONSTAR. If you do
however, it is ESSENTIAL to re-ionize thoroughly.

Allow yourself time to complete the described process, this way you can
ensure achieving optimum results.