WARNING: Please read the Safety Instructions before using the speaker.
1. MOUNT SPEAKER TO 1 3/8” (35mm) PA SPEAKER STAND (not included)
Use one hand to lift the speaker by the handle and use your other hand to support the speaker
as you guide it onto a conventional PA speaker stand.
2. MAKE SURE POWER SWITCH IS OFF
The “O” indicator on the switch is pushed in.
3. PLUG IN THE SPEAKER
Plug the included power cable into the speaker IEC Input Module first and then into the wall outlet.
4. TURN MASTER VOLUME DOWN
Make sure the master volume is turned all the way counter-clockwise.
5. TURN THE SPEAKER ON
The “|” indicator is pushed in. The speaker may take a few seconds to turn on completely.
6. PLUG IN THE INSTRUMENT OR MIC CABLE
Plug your instrument or mic cable into Ch1 or Ch2.
7. ADJUST THE GAIN
Adjust the gain to the appropriate level for your instrument or vocal microphone by turning
the control clockwise. An LED will flash red to indicate clipping the input stage. Pushing the
input too hard may cause unwanted distortion.
8. UN-MUTE CH1 (or Ch2 if you chose that channel)
Check the mute light. If it is lit, then un-mute the channel by pushing the mute button.
The light should now be off.
9. ADJUST THE MASTER VOLUME
Turn the master volume knob clockwise to the desired volume level.
10. ENJOY!
QUICK START
Summary of Contents for Synapse
Page 1: ...User s Guide ...
Page 5: ......
