USER
USER
USER
USER’’’’S
S
S
S MANUAL
MANUAL
MANUAL
MANUAL OF
OF
OF
OF LK-330E
LK-330E
LK-330E
LK-330E
LABEL
LABEL
LABEL
LABEL &
&
&
& MARK
MARK
MARK
MARK INDUSTRIES
INDUSTRIES
INDUSTRIES
INDUSTRIES COMPANY
COMPANY
COMPANY
COMPANY
19
2.3.3
2.3.3
2.3.3
2.3.3 Installation
Installation
Installation
Installation of
of
of
of sleeve
sleeve
sleeve
sleeve tube
tube
tube
tube guide
guide
guide
guide
1. Open the protective cover
�
Make sure the printer is installed with an Ribbon.
2. Put the tongue on the right side of the guide into the trough of printing material
cassette holder on the printer.
3. Press the guide until you hear a “crack” sound, which indicates the sleeve tube
guide has been installed to its position. Make sure the tongue has returned.
Installation of Sleeve Tube Guide
4. Close the protective cover
2.3.4
2.3.4
2.3.4
2.3.4 Installation
Installation
Installation
Installation of
of
of
of sleeve
sleeve
sleeve
sleeve tube
tube
tube
tube
1. Open the protective cover.
�
Make sure that the Ribbon and sleeve tube guide have been properly installed.
2. Feed the sleeve tube from the feeding opening on the sleeve tube guide until its
front end reaches the print rubber roll.
[Attention]
[Attention]
[Attention]
[Attention]
The sleeve tube to be fed shall be at least 30cm long.
Be sure to feed the front end of the sleeve tube that is soft or has an excessive
deformation between the Ribbon and the print rubber roll.
See that the sleeve tube is properly fed. The pulling stress exerted by the machine
shall not exceed 500G, otherwise the machine may not work properly.
