3 of 4
00000050209
STEP 14
Line up the end of one rail (finished side out) with the
pre-drilled holes in the headboard (finished side with the
wood button facing towards the rail). Insert a bolt
through each hole so that it screws into the barrel nut in
the rail. Using a Phillips head screwdriver, tighten the
bolt (the use of a flat head screwdriver to hold the barrel
nut in the correct position is recommended).
STEP 15
Place footboard end (wood button side in) at the foot of
the bed. Repeat step #14 to attach.
NOTE: Full, Queen, and King sizes – Leave the bolts
loose for steps 16 and 17.
Twin side skip to step #18
STEP 16
FULL and QUEEN size: Locate the long support bar
with screws attached to either end, and the small wooden
leg with the 2” wooden dowels attached. Line up the
dowels in the wooden leg with the pre
-
drilled holes in
the center of the support bar. Tap into place. Line up the
support bar so that the screws at either end fit into the
notch on the metal brackets found on the frame ends.
Push down to lock into place.
KING size: Follow Full/Queen instructions for both
support bars.
STEP 17
Tighten all bolts
STEP 18 ALL SIZES
Locate the four 1¼” fluted dowels. Put one dowel into
each of the pre-drilled holes located on the inside edges
of the rails. Tap into place. Unroll the webbed slat
system into the frame. The dowels will hold the last slat
on each end in position. Using the screws provided,
secure the middle slat onto the rails through the pre-
drilled holes.
STEP 19
Tap the wood buttons into place on the outside of the
headboard and footboard and on the headboard posts to
cover the bolt holes.
CARE
Use a clean soft cloth to dust.
