For more information regarding the use and setup of this tent, please call our Product Support Team at 800-CAMPLLB.
1. Take one of the long fiberglass poles and slide it
through the sleeve located over one of the side
rooms of the tent. These sleeves have an orange
opening. If one of the pole’s ferrules (the part
that connects the pole’s pieces) comes apart
or gets caught on material inside the sleeve, do
not try to force it through. Simply make sure the
ferrules are seated properly, back the pole out a
little and try again. Make sure the fiberglass pole
goes over the aluminum pole of the main room.
Repeat on the sleeve located over the other side
room of the tent (Fig. 8).
5. Attach the clips located on the corners of the
main room to the leg poles. There are 2 clips at
each corner (Fig. 7). Be sure that the top clip
is attached just below the sleeve on the bent
elbow of the leg pole.
Installing the Fly
2. Insert the tips of the long fiberglass poles into the
grommets with orange webbing (Fig. 9). These
are located adjacent to where the aluminum
poles are attached.
Fig. 8
Fig. 7
Setting Up The Side Rooms of Your Tent
3. Locate the hard plastic clips and bungee loops
where the fiberglass and aluminum poles cross
each other. At each of these 4 spots, wrap the
bungee twice around the two poles and secure
the bungee onto the clip.
4. Now you’re ready to finish staking out your
tent. Loosen the webbing on the stakeout loops
located at the outside corners of the side rooms.
Pull them out before driving the stake through
the loop and securely into the ground. Tighten
the webbing on the stakeout loop (Fig. 10). The
main room is now complete (Fig. 11).
1. Slide the fly over the main room of the tent so
the dark green sides are oriented over the tent’s
side rooms. The light green sides should be over
the tent doors. (Fig. 1A).
2. Locate the 4 clips at
the corners of the fly
and connect them to
the
corresponding
clips on the main tent
body (Fig. 2A).
Fig. 2A
Fig. 3A
Fig. 4A
4. Once the fly is positioned correctly over the tent,
reach under the fly at each corner and attach
the 2 Velcro loops to the tent’s aluminum leg
poles.
3. The two remaining short fiberglass poles are
used to create awnings over each of the tent
doors. Undo one of the fly clips and slide the
awning pole into the sleeve located on the
underside of the fly (Fig. 3A). Place each end of
the awning pole into the grommets located in a
clip panel that extends off the tent body (Figure
4A). Reattach the fly clip. Repeat for the awning
over the other door.
Fig. 10
Fig. 1A
Fig. 9
Fig. 11
