Maintenance
29
X8 user manual (EN) version 2.0
5.
While holding the cone in place, drive the center screw manually using the Allen wrench.
6.
Secure the cover with four S182 screws.
a) Gradually secure each screw manually with the Allen wrench n°3.
Follow a cross scheme.
1
4
2
3
b) Tighten the screws in the same order with the electric screwdriver.
Use the 3 mm hex bit. Set the torque to 1.7 Nm.
7.
While holding the cone in place, tighten the center screw with the electric screwdriver.
Use the 3 mm hex bit. Set the torque to 1.7 Nm.
8.
Place the gasket on the LF driver.
9.
Carefully position the HF driver on the LF driver.
Use the connectors as reference points. When facing the LF driver connectors, the small HF driver connector must be
on the left, and the larger one on the right.
10.
Secure the HF driver on the LF driver with the two screws.
Use the 3 mm hex bit. Set the torque to 3 Nm.
