Rigging procedures
Rigging procedures
Wall- or ceiling-mounting X4i with a bracket
wall-mounting
type of deployment
ceiling-mounting
rigging accessories
X-U4i or X-B4i
additional material
2 x
∅
6 mm / M6 screws and anchors (depending on the support material)
blue threadlocker
torque screwdriver
tools
T25 Torx bit
Secondary safety for own enclosures
Use one insert at the back of the enclosure to implement a secondary safety.
Fasteners for wall-mounting or ceiling-mounting
Secure the bracket with two M6 screws.
Select screw length and anchors applicable to the wall or ceiling properties.
The procedure is shown with X-U4i.
The same procedure applies for X-B4i.
Assembly
Procedure
1.
Secure X-U4i or X-B4i to the wall or to the ceiling using two M6 screws.
2 x Ø 6.6 mm /
0.26 in
70 mm / 2.8 in
2 x Ø 6.6 mm /
0.26 in
70 mm / 2.8 in
X-U4i
X-B4i
2.
On both sides of the enclosure, remove the screws.
T25
32
X4i owner's manual (EN) version 4.0
Summary of Contents for X4i
Page 1: ...X4i owner s manual EN ...
