SB18i_RM_EN_1.1
w w w . l - a c o u s t i c s . c o m
8
SB18
i
SUBWOOFER
rigging manual
VERSION 1.1
4
SUBSET PROCEDURES
Dismantling an array
Apply the associated set-up procedure in reversed order.
PROCEDURE A
Attaching an SB18i to a second enclosure
Tools
Electric screwdriver with torque selector.
T30 bit.
1.
Attach four arms to a SB18i.
a.
Unscrew the five 35 mm Torx
®
screws on one corner of the enclosure.
Use a T30 bit.
b.
Position an arm with its bended part at the top and oriented outwards on the corner on the enclosure.
c.
Align the five holes of the arm and the holes of the enclosure, and slightly drive the five screws.
The four arms are identical and can be identified by the number 611 engraved on each one.
d.
Repeat for the remaining corners.
2.
Attach four arms to a second SB18i.
a.
Leave the bottom holes free.
b.
Fully drive the screws in all the other holes.
3.
Attach the two enclosures.
a.
Stack the second enclosure on top of the other.
b.
Align the bottom holes of the second enclosure with the top holes on the first enclosure arms.
c.
Drive a screw through each hole and fully drive all the screws on the enclosures.
Use a T30 bit and set the torque to 5 N.m / 45 in.lbf.
If the bottom SB18i is not the last enclosure in the array, remove and keep the screws from the
bottom holes to be able to attach it to the top enclosure of the next stack.
