— 7 —
5. Getting started
5-1. Measurement mode and parameter setting mode
Pull the trigger on the instrument to take a measurement. Press the
F
button
(Function button) to use other functions.
The main display shows measured values and the sub display shows values
obtained with each function. The following flow chart shows the sequence and
corresponding action.
Measurement mode
Parameter setting mode
SCAN
●
MAX
：
Shows the maximum value taken
during one measurement on the sub display.
●
MIN
：
Shows the minimum value taken during
one measurement on the sub display.
●
SCAN
：
Shows measured values.
●
AVG
：
Averages the values taken in one
measurement and shows it on the sub
display.
●
TC
：
Shows measured values with using
K-type thermocouple.
MAX
TC
●
EMS
：
Shows emissivity. (P. 10) Use the
cursor buttons to alter emissivity.
●
HAL
：
Shows the upper limit for alarm. (P. 8)
Use the cursor buttons to alter the limit value.
Red backlight blinks when a measured value
exceeds this limit.
●
LAL
：
Shows the lower limit for alarm. (P. 8)
Use the cursor buttons to alter the limit value.
Red backlight blinks when a measured value
falls behind this limit.
* Auto power off function activates in 6 seconds. When the display becomes blank due to
this power off function, pull the trigger.
HAL
MIN
AVG
LAL
EMS
5. Getting started
