̶ 20 ̶
5. How to review the measured DAR/PI values
Press the DISP button when measurements end. The measured
results are then displayed in following sequence. If the measure-
ment ends earlier than the intervals described in below (2), (3) or
(4), blank displays aren’t shown and returns to (1).
(1) End of test
(A) Time when a test ends
(B)
Value measured at the end
of test (resistance value)
(C)
DAR or PI value
(whichever was displayed at
the end of test)
(2) Results at 15 or 30 sec after a start of test
(A) Elapsed time (15 or 30 sec)
(B)
Value measured 15 sec after
a start of test. (resistance
value, output voltage)
(C) DAR value
(3) Results at 1 min after a start of test
(A) Elapsed time (1 min)
(B)
Value measured 1 min after
a start of test. (resistance
value, output voltage)
(C) DAR value
(4) Results at 10 min after a start of test
(A) Elapsed time (10 min)
(B)
Value measured 10 min after
a start of test. (resistance
value, output voltage)
(C) PI value
Return to (1)
(A)
(B)
(C)
(A)
(B)
(C)
(A)
(B)
(C)
(A)
(B)
(C)
