Kyocera TASKalfa 7353ci, Operation Manual

Page: 316 / 723

6-29
Using Various Functions > Functions
Punch
Punches holes in sets of finished documents.
NOTE
• This function requires the optional Document Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Punch Unit (For 4,000-sheet/100-sheet Staple Finisher) (page 11-26)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item Value Description
Punch Off
2 holes Left Select the position of punch holes. For details on original
orientation and position of punch holes, refer to the
following:
Original Orientation and Punch Hole Position (page
6-30)
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original
Orientation Top Edge on Top, Top Edge on Left,
Auto Select the orientation of the original document top edge
to scan correct direction. Select [
Original Orientation ]
to choose orientation of the originals, either [ Top Edge
on Top ] or [ Top Edge on Left ]. Then select [ OK ].