KYOCERA Corporation
6274 SERIES INSTRUCTION MUNUAL
No.205-03-200
106-03-004
PAGE 4/6
4
.
FPC,FFC
装着作業手順
How to engage an FPC/FFC
(1)「スライダー」を開ける
Open the slider.
「スライダー」を図のように引き上げてください。一定の高さ(約 2.1mm)までしか上がりませんので、硬く
なったらそれ以上無理な力を加えないように注意してください。
Pull up the slider in the direction shown by the arrow in the figure below. Since the slider is lifted up
approximately 2.1mm at maximum, do not apply any further force when it stops.
(注)スライダーはロック状態で納入されます。
(Note) The slider is closed and locked when shipped.
(2)FPC,FFC を装着する
Insert the FPC/FFC into the connector.
図のように、FPC、FFC をインシュレータの底に突き当たるまで挿入してください。
尚、コネクタに対し平行に挿入してください。
Insert the FPC/FFC into the connector until it hits the bottom of the connector slot as shown in the
figure below. Insert the FPC/FFC right straight down into the slot.
スライダーを持ち上げる時は操作部を水平に持ち上げてください。
Don’t pull up the operation parts of the slider at a tilt
FPC、FFC
FPC、FFC