User Guide for the Kyocera 3250 Phone
iii
FCC/IC Notice
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
To maintain compliance with FCC RF exposure guidelines, if
you wear a handset on your body, use the Kyocera Wireless
Corp (KWC) approved case CA90-G2701 or holster 50-L2440.
Other accessories used with this device for body-worn
operations must not contain any metallic components and
must provide at least 15 mm
=
separation distance, including the
antenna, and the user’s body.
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These
limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The
guidelines are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include
a substantial safety margin designed to assure the safety of all
persons, regardless of age and health.
The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is 1.6 W/kg.* Tests for
SAR are conducted using standard operating positions
specified by the FCC with the phone transmitting at its highest
certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be
well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the
power output.
Before a phone model is available for sale to the public, it must
be tested and certified to the FCC that it does not exceed the
limit established by the government-adopted requirement for
safe exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as required by
the FCC for each model. The highest SAR values for this
model phone are:
Cellular Band (Part 22)-Head:1.26 mW/g; Body-worn:
0.47 mW/g with KWC case CA90-G2701-01, 0.81 mW/g with
15 mm air separation; Face: 0.39 mW/g with at least one inch
(2.5 cm) separation.
PCS Band (Part 24)-Head:1.30 mW/g; Body-worn: 0.28 mW/g
with KWC case CA90-G2701-01, 0.53 mW/g with 15 mm air
separation; Face: 0.20 mW/g with at least one inch (2.5 cm)
separation.
Recommended body worn accessories are only intended for
use with the standard battery door, not the sport clip.
(Body-worn measurements differ among phone models,
depending upon availability of accessories and FCC
requirements. The body-worn SAR values provided above
were obtained by using Kyocera Wireless Corp. (KWC)
approved case CA90-G2701-01 and holster 50-L2440-01. The
sport clip is not designed to be a body-worn accessory).
While there may be differences between the SAR levels of
various phones and at various positions, they all meet the
government requirement for safe exposure.
The FCC has granted an Equipment Authorization for this
model phone with all reported SAR levels evaluated as in
compliance with the FCC RF emission guidelines. SAR
information on this model phone is on file with the FCC and
can be found under the Display Grant section
http://www.fcc.gov/oet/fccid after searching on FCC ID
