HAND CRIMPING TOOLS
Type
A
Structure of the Tool and Part Names
This tool can crimp an applicable wire easily with a set of crimper and anvil.
No need to replace the crimper and anvil.
Example of Failure
Selecting the appropriate crimper
1.Requisite blades are attached on top and bottom of the crimper.
2.Combine blades for the crimper so that chamfered planes are faced.
3.Select the crimper to the size of the wire.
4.The number of applicable size of the wire is engraved on the crimper.
5.When replacing the crimper, pull out the locator pin.
(The locator pin can be pulled out with fingers easily.)
は素手
簡単に抜けます）
珥上歯型をセットしロケーターピンで固定してください。
Procedures
1.Make sure that the tool number and the wire size are met.
2.Open the grips fully.
3.Set the contact appropriately as shown in Figure A".
〈注〉
（刻印端子の被覆圧着側です。）
4.Insert the stripped wire as shown in Figure A".
5.Close the grips fully until the ratchet is released.
6.Open the grips to pick up the contact.
7.Make sure that the crimped work is free from defect.
Failure Item
1)
Malformation of
the crimped area
(Wire barrel)
Failure Description
Cause
Pull strength is
out of specification.
The wire size is out of
the specification,
or abrasion of the tool
2)Deformation
of the terminal
1.Bend
2.Twist
3.Deformation
of the barrel
3)Variation in
crimp height
The crimping height
of the tool is not fixed.
Occurred when grips
are
incompletely
tightened (tightened
half way) but in the
position where they can
be open due to the
abrasion or deformation
of the ratchet.
The terminal
i
s not
set in position against
the crimper and anvil.
6.Install the appropriate crimper and fix it with the locator pin.
Note: The cladding insulation is placed at the side on which
the engraved indications are shown.
Locator pin
Crimper
Anvil
Tool identification number
Ratchet
Figure A"
Wire crimper
Contact
Cladding insulation crimper
Crimper
Cladding insulation
Anvil
Wires
Bent up
Twisted
Rolling
Twisted
Bent down
Incomplete
crimping of the barrel
