Kyocera Mita FS-1050, Operation Manual

Page: 27 / 209

Using the Operator Panel
1-17
11 — KIR Test Pattern
KIR is the Kyocera original smoothing function. This test pattern shows
the effect of the KIR (Kyocera Image Refinement) system.
Changing the Interface Parameters
The printer is equipped with parallel and USB interfaces. In addition, it is
possible to add an optional serial interface to the printer. Various printing
environment parameters such as the default emulation can be changed
independently of the interface by using the printer’s menu selection
system. First, select the interface to which the changes apply using the
procedure described below.
The interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
from which data is received.
Selecting a Parallel Interface Mode
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this interface is used in the
Auto
mode as default.
For details, see Appendix C Appendix C Appendix C Appendix C . After selecting an interface, reset or restart
the printer. Only after you do this does the change take effect.
1
Press the
MENU
key.
2
Press the or key until
Interface >
appears. One of the
interface names shown below appears, indicating the current
interface.
Parallel
(default)
USB
Serial
(option)
Option
(with a network interface card installed)
3
Press the
ENTER
key. A blinking question mark (
?
) appears.
If
Parallel
is not displayed, press the or key until
Parallel
appears.
If you want to abandon this procedure, press the CANCEL key. The
interface remains unchanged.
4
Press the ENTER key again.
Note
Interface
? Parallel