8
16 September 2020
700-00141-000 revA Kymeta u8 vehicle mounting kit installation guide
© 2020 Kymeta Corporation. All rights reserved. Kymeta Corporation Confidential –
Subject to confidentiality obligations.
6
Assemble the u8 vehicle mount accessory
6.1
Install the cross bar
1.
Install roof rack cross bars at desired longitudinal location per manufacturer’s instructions. Ensure the cross bar
spacing is approximately 1010 mm (39.76 in.) as measured from the center of the crossbars.
2.
Verify the spacing by dry fitting rail component (Item A) to confirm crossbar is centered on rubber mounting pads.
6.2
Integrate the u8
1.
Clear
a flat surface
: ensure it is clean with no objects or debris that may damage the u8.
2.
Unpack the u8. To open the case, lay it flat on an open area where it's easy for one person to stand on each side
near the clean assembly surface.
3.
With two people (one person on each side), lift the u8 out of the case, keeping the u8 parallel to the floor, and lay
it face down on the clean flat surface. Place a piece of foam, fabric, or non-abrasive material on the clean flat
surface to prevent marks or damage to the face of the antenna.
4.
Place the rails so that mounting bolt locations align with antenna fastener points and that the Kymeta branding is
visible from the outside.
