CONTROLS & FEATURES
①
Service indicator: It lights up every 2000km
to remind you to do oil service.Whenever
the ignition switch is turned on, it goes on
then off after self diagnose .
②
ABS indicator:It lights up when the ignition
switch is turned on and will turn off after
the vehicle starts moving.It will stay off as
long as the ABS system works normally.
③
High Beam Indicator Light: This light is
illuminated when the high beam is on.
④
CELP indicator: If it keeps on after start the
engine, it indicates that a fault has been
detected in the EFI or electrical system.
Need immediate inspection by the
authorized KYMCO dealer.
▆
NOTE:
Open the ignition switch, The CLEP indicator
will illuminate always. after Starting it was crush out
⑤
Tachometer: Indicate the engine revolution
speed in RPM.
⑥
Speedometer: Indicates the road speed in
kph or mph.
⑦
Battery Voltage and Digital Clock:
It displays the battery voltage or clock.
⑧
Fuel Warning Indicator
“
“: It turns on
when the fuel tank is near empty ,it alerts
the rider to refill the fuel tank as soon as
possible.
⑨
Odometer/Trip meter:
˙
Press MODE button to toggle between ODO
mode, Trip mode and oil service or empty
mode
˙
Choose Trip or oil service mode,hold both
MODE and ADJ for 2 senconds to reset .
˙
Press ADJ to switch between km display
and miles display.
⑩
USB Charging Indicator: Plug electronic
device in,the indicator will be ON when it
is charging,it will be OFF when it is not
charging. It will flash when the battery
voltage is too low.The circuit will be cut off
if the electric current is over-load to
protect your device.
⑪
Turn Signal Indicator Light: Flashes when
either turn signal is being used.
1 1