Advanced Configuration
41
Figure 40 Selecting PVLAN Members
PVLAN List
Options: select/deselect
Default: deselect
Function: Select PVLAN members.
Note:
Both shared and isolation domains are member VLANs of PVLAN.
6.3.3 Typical Configuration Example
Figure 41 shows a PVLAN application. VLAN300 is a shared domain and port 1 and port 2
are uplink ports; VLAN100 and VLAN200 are isolation domains and port 3, 4, 5 and 6 are
downlink ports.
Figure 41 PVLAN Configuration Example
Configuration steps:
1. Configure the shared domain, VLAN 300, as shown in Figure 39.
Set port 1 and port 2 to Untag ports and add them to VLAN 300.
Set port 3 and port 4 to Tag ports and add them to VLAN 300. Enable PVLAN on the two
ports.
Set port 5 and port 6 to Tag ports and add them to VLAN 300. Enable PVLAN on the two
ports.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
