Advanced Configuration
35
Description: The transparent transmission mode indicates whether the switch checks
incoming packets on a port. If Nonmember Drop is selected, a packet is discarded when the
VLAN tag of the packet is different from the VLAN of the port. If Nonmember Forward is
selected, a packet is accepted when the VLAN tag of the packet is identical with that of any
other connected port on the switch; otherwise, the packet is discarded.
2. Create a VLAN.
Click <Add> in Figure 32 to create a VLAN. As shown in the following figure, select the ports
to be added to the VLAN and set port parameters.
Figure 33 VLAN Configuration
VLAN Name
Range: 1~31 characters
Function: Set the VLAN name.
VLAN ID
Range: 2~4093
Function: Configure the VLAN ID.
Description: VLAN ID is used to distinguish different VLANs. This series switches support a
maximum of 256 VLANs.
VLAN Member
Options: Tagged/Untagged
Function: Select the type of the port in the VLAN.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
